In this video, we describe using Horos imaging software for Mac iOS to plan poly axial screws sizing and trajectories at a typical location - T11. The same techniques would be used for CT scans and other imaging software.

In this video, we show how to assemble the Bolt-Mini Poly Axial screw and insert it into the pre-drilled hole.

This video describes a hand drilling technique which can be used for small poly axial screws - usually less than 2.7mm in diameter.

This video show how to conform the 2.2mm Titanium Rod to fit the poly axial screw tulips. This video covers simple bends mainly using the Rod Bender instruments. See the “complex” video for other tips.

in this video, we demonstrate a few different techniques and instruments which can be useful aids for complex shaping of Titanium Rods.

In this video, we show the final assembly of the construct by adding caps and making sure they are tightened to exact specifications. We go over several tips which can be useful for final assembly and discuss the instruments used in the process.